SINGER W1466 - Manual (Page 29)

27
ADJUSTING AND CHANGING V BELT
Fig. 41 Fig. 42 Fig. 43
Following are the instructions for adjusting and changing the "V" belt.
(1) Remove three screws holding rear cover (Fig. 42) by tipping it out at the bottom and
pivoting around the hand wheel away from the front of the machine.
(2) To adjust "V" belt, loosen screws A, Fig. 43 and move bracket B up to loosen belt and
down to tighten.
(3) To remove "V" belt;
(A) Remove top cover. ■
(B) Loosen clutch C, Fig. 42 .
(C) Loosen screws "A" (Fig. 43) and move bracket "B" to its highest position.
(D) Slip belt off motor pulley and then over hand wheel.
(E) Replace "V" belt by slipping it over hand wheel and then over motor pulley.
(F) Adjust as noted under No. 3.
r