Upper threading single needle, Placing bobbin case in shuttle – SINGER W1065 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
Open hinged cover plate in front of the needle. (See 20, Fig.
1
)
Hold the bobbin case latch,
( A ) , Fig. 10, between the thumb and forefinger of the left hand, with at least three inches of
thread running from the top of the bobbin case to the right. Insert and center the bobbin case
on the stud of the shuttle body, <B i. Be sure the bobbin case finger, ( C ¡, is opposite the shuttle
race notch, i D). Press the bobbin case l E ) into the shuttle as far as possible until latch catches
on the center post of the shuttle. THEN release the bobbin case latch, l A ) . Press bobbin case
again after latch has been released to make sure the bobbin case is locked securely in place.
Close the cover plate.
UPPER THREADING SINGLE NEEDLE
Turn the balance wheel toward you to raise the take-
up and needle to their highest position.
Plac spool of thread on spool pin,
lead thread under arm thread guides and by a circular
motion with your left hand lead thread through guides
down and around one set of tension discs from right
to left,
into notch on the right hand side of check spring over
threaded discs
under thread guide bar and into guide 8.