Binder, Folded binding (fig. 86), Two-tone binding ( fig. 87) – SINGER W1065 User Manual
Page 45: Hand-cut bias binding (fig. 86), I # 47
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I #
47
B I N D E R
This attachment folds bias binding, applies it to the edge of material in one operation,
on scroll of the binder are for corresponding widths of commercial folded bias binding.
The open mouth of binder scroll is used for unfolded bias strips cut 15/16 inch wide.
FOLDED BINDING
(Fig. 86)
Cut a point on folded binding, insert in appropriate
slot.
Draw
through
slot
and
under
binder
with
strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.
TWO-TONE BINDING
( Fig. 87)
Two bindings can be sewn on fabric edge also in one
operation. When two are used, always skip one size be
tween widths, inserting each in correct size slot.
HAND-CUT BIAS BINDING
(Fig.
86)
Slots
Cut 15/16 inch bias binding fold in half for a couple
of inches. Cut binding diagonally toward end, almost to
fold. Slip fold into center of binder. Draw back until
cut opens and binding encircles open end of scroll. Test
stitching to be sure it is on the edge adjust if necessary.
See Fig. 84
and
85
for
suggestions
on how to use
the
binder.
There
are
hundreds
of
other uses.
Finr A.R
Fig. 86
Fig. 87