SINGER W1065 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
%
% >
•
^
• >
i >
• a ^
^ э
' 1
»5 3
%
3
^ 3
^ 3
S 3
^ 3
% 3
4
3
7.
Up into take-up lever from right to left.
8.
Down through guide in thread bar again.
9.
Into guide inside face.
10.
Through needle clamp guide and into
needle from front to back pulling three
to four inches of thread through needle.
(See Fig. 12s
Hold the end of upper thread loosely and
turn hand wheel toward you until the needle
goes all the way down and comes back up.
A loop (.Fig. 11) will be formed over the
upper thread which then can be pulled out
straight.
Place
both
thread
ends
under
the
slot of the presser foot and draw toward the
back
of
the
machine,
leaving
both
threads
three or four inches long.
Fig. 11