Operating the machine, Choosing and changing needles, Connecting the machine – SINGER 6610 User Manual

Page 11: Running the machine

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating the machine

Connecting the machine

Push plug (1) into the receptacle (2) at the
right end of the machine. Then connect plug

(3) to your socket outlet.

Running the machine

To turn on machine and sewing light, press

upper portion of power switch (4). To turn
off machine and light, press lower portion **0”
of power switch.

To run the machine and contol speed, press
the foot control (5) with your foot. The harder
you press, the faster the machine will sew.
To stop machine, remove foot from control.

Note: Do not operate machine without fabric
under the presser foot as this may damage

the feed and the presser foot.

Choosing and changing
needles

Important: For best results from your sewing
machine, use only SINGER*needles. Check

the needle package, and the Fabric, Thread
and Needle Table on page 09 for the correct

needle and fabric combination.

• Raise needle to its highest position.

• Loosen needle clamp screw and remove

needle.

• With flat side of needle to the back, insert

new needle up into clamp as far as it will

go.

• Tighten needle clamp screw securely.

)6

Advertising