Caring for your machine, Removing and replacing, Bobbin case – SINGER 6610 User Manual
Page 43: Removing and replacing bobbin case
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^
r
38
9. CARING
FOR YOUR
MACHINE
Removing and replacing
bobbin case
Caution: Before cleaning or adjusting the
machine, remove plug from the socket outlet.
• Raise presser foot and needle.
• Open slide plate, remove bobbin and
remove needle plate.
To remove bobbin case
e With a small screwdriver, turn bobbin case
holder (1) to the rear as far as it will go.
e Lifting the left side of the bobbin case, slide
it out from machine.
To replace bobbin case
e Guide forked end (2) of bobbin case under
fe^d (3).
• Draw rim of bobbin case under position
plate (4). Be sure bobbin case is freely
seated on hook race.
e Turn bobbin case holder (1) forward as far
as it will go, locking bobbin case in place.
Note; Turn handwheel towards you to check
to make sure It is properly replaced.
• Replace needle plate (see instruction on
page 08)
• Insert bobbin and close slide plate.