SINGER WRotary (Book 13) User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ment. The design to be braided should be plainly marked or
stamped on the top or right side of the fabric. Start the soutache
braid into hole ' K” and stitch along design, being sure that the
soutache braid is feeding freely into hole "K” without twisting.
To turn a corner, stop the machine w i t h the needle down
tliiough the brail! m the exact corner of the design, raise the
presser-bar just enough to perniit the turning of
the
fabric
ill the desìied direction, lower the presser-bar and proceed
as before.
The Scissors Gauge
for cutting bands of various widths, either straight or bias.
File sliding .scale is adjustable for the widths of band desired.
IM inch indicates the proper
width for a bias fold, which is to
be H inch wide when finished.
One inch indicates the width
for cutting bias bands which are
used with fhi^
1Ä,
1
Fig. 19
Place the gauge upon the scissors, as s’liowng slir> tlie edge of
I h.c cloth. HI the gauge and icroceed to cut tl.ie band, ,1'li.e tap'e
lor tlie IniKlcr sJiouId always be cut on tlie l)ias also iJie piping
wliich, rs used with the rufiler.
Biiiciiiig