Nortel Networks T7316 - Manual (Page 28)

28 Chapter 1 Telephone configuration overview
P0937240 03.1
Display exceptions
The Companion, DECT, and NetVision handsets have multi-line displays, but they do not have
display buttons and so do not display the prompts.
• The NetVision telephone has a two-line display. The display is 10-characters-per-line.
Therefore, the standard 16-character displays are split across the two lines, and there is no
display of softkey labels.
• The NetVision Data telephone has a 16-line display, with 12 characters per line. The standard
16-character displays are split across the first two lines, and there is no display of softkey
labels. Refer to
Table 3 .
Buttons under the display
The three buttons found under the display are for interacting with the programming prompts or
internal menus, in the case of IP and NetVision telephones. The programming session determines
what the display shows and what each button does. Some display instructions are
OK , CHANGE or
COPY . In this guide, display button instructions appear underlined.
All examples in this guide show the digital 16-character, two-line display.
Describing the display buttons
Some display buttons, such as TRANSFR and ALL, are shortcuts that are only available on a two-line
display. Other display buttons, such as OK and SHOW, perform a function necessary to proceed.
Table 3 shows display button functions and dialpad buttons on a one-line display telephone.
Table 3 Display button equivalents on a one-line display telephone
Display buttons
Dialpad display buttons on T7100, T7208, M7100(N), M7208(N)
and NetVision telephones
OK
≥ or ˙ or on NetVision:
QUIT
® or ® or on NetVision:
ADD •
SHOW £
CANCEL £
VIEW £
OVERRIDE £
HOLD HOLD
END END