Datalogic Scanning Compact 2D Reader Matrix-2000 - Manual (Page 82)

MATRIX-2000™ REFERENCE MANUAL
8
8.4 CONFIGURATION
Once connected to Matrix-2000™ as described in par. 8.3, you can modify the configuration
parameters as follows:
1. Press the Calibration Tool button from the Main Menu. Matrix-2000™ will download its
permanent memory configuration parameters with the default values (if it is the first time)
to VisiSet™. The Calibration Tool window will be displayed together with the Parameter
Setup window working in Interactive Mode (see par. 8.4.1 and par. 8.4.3).
2. Edit the Matrix-2000™ configuration parameters according to your application
requirements.
3. Use the Calibration Tool to fine tune the reading performance. See par. 8.4.3.
4. Close the Calibration Tool window and disable the Interactive Mode by pressing the
interactive button.
5. Save the new configuration to the reader permanent memory by pressing the Send
button.
6. Close the Parameter Setup window and press Disconnect on the VisiSet™ menu bar
(see Figure 94) or launch Run Mode from the VisiSet™ Main menu.
Disconnect exits closing communication between Matrix-2000™ and VisiSet™, and
causes Matrix-2000™ to enter Run Mode. The disconnected reader serial port is now
available.
Run command does not close communication between Matrix-2000™ and VisiSet™,
and causes Matrix-2000™ to enter Run Mode. In this case the reader output
messages are displayed on the VisiSet™ terminal and the statistics are displayed in
the Statistics window (Statistics enabled).
72