3DLABS Wildcat 4210 - Manual (Page 14)

7
2 Setup
This chapter provides step-by-step instructions for installing the video card and related software, and
connecting the monitor and stereo display device.
Preparing for Installation
NOTE: If you purchased your Intense3D Wildcat 4210 video card as part of a system, it was installed
and configured prior to shipment. The following instructions for hardware installation are
necessary only if you purchased a customer kit or need to reinstall your video card.
NOTE: Refer to your system’s documentation for instructions on opening and closing the system,
identifying the AGP Pro 110 expansion slot, Peripheral Component Interconnect (PCI)
expansion slots, and adding expansion cards.
Make Sure Your Computer is Ready
General system requirements include:
♦
Pentium II or greater processor
♦
Microsoft Windows NT 4.0 with Service Pack 5 or later or Windows 2000
♦
AGP Pro 110 expansion slot
NOTE: The Intense3D Wildcat 4210 video card cannot plug into a standard AGP slot.
♦
Two open PCI slots adjacent to the AGP Pro 110 slot
♦
Minimum of 32 MB DRAM (64 MB recommended)
♦
Industry-standard, multiple-frequency monitor (VGA) or a Digital Video Interface
(DVI)-compliant digital display device
♦
3 MB of free space on the computer’s primary system disk for the video display driver
software