3DLABS Wildcat 4210 - Manual (Page 21)

14
7. Once the driver successfully installs, click Finish to dismiss the Found New Hardware
Wizard.
NOTE: Windows 2000 recognizes the dual pipelines as two devices. The Found New Hardware
Wizard will display a second time to finish the installation.
CAUTION: You must repeat Steps 3 – 7 above to complete the installation.
8. When told that the workstation must be restarted for the new settings to take effect,
remove the delivery media from the disk drive (if applicable) and click Yes to restart the
workstation.
NOTE: See “Configuring the Video Display in Windows 2000” later in this document for instructions on
setting the display properties.
Installing Heidi
®
Drivers for AutoDesk Applications
The Intense3D Heidi device driver allows full screen multisampling of and compatibility with AutoDesk
applications as well as hardware acceleration of the Wildcat 4210 through the use of OpenGL. To install
the Heidi driver and to activate full screen multisampling, consult the
README . TXT located on disk 3 of the
Wildcat 4210 delivery media.
Verify the Default Video Display Driver
If you’re running Windows NT 4.0
To verify the default video display driver:
1. From the operating system Start menu, go to Settings/Control Panel/Display, and click
the Settings tab on the Display Properties dialog box.
2. Click Display Type, then verify that Intense3D Wildcat 4210 is listed under Display. This
indicates that the appropriate driver is installed.
3. Click Cancel to close the Display Properties dialog box.
If you’re running Windows 2000
To verify the default video display driver:
1. From the operating system Start menu, go to Settings/Control Panel/Display, and click
the Settings tab on the Display Properties dialog box.
2. Verify that two Intense3D Wildcat 4210 devices are listed under Display. This indicates
that the appropriate driver is installed.
3. Click Cancel to close the Display Properties dialog box.