3DLABS Wildcat 4210 - Manual (Page 22)

15
Verify the System Startup Version
If you’re running Windows NT 4.0
To verify the default system startup version:
1. From the operating system Start menu, go to Settings/Control Panel/System
2. Click the Startup/Shutdown tab.
3. Verify that Windows NT Workstation Version 4.0 is selected in the Startup list. If it is
not, select it from the list and click Apply.
NOTE: Do not select the VGA version of the operating system. The video display runs in VGA mode
when the Intense3D Wildcat 4210 graphics driver is not running.
4. Click OK to close the System dialog box.
To check the video image:
1. If the Display Properties dialog box is not already displayed, go to the operating system
Start menu, select Settings/Control Panel/Display, and click the Settings tab.
2. Click Test to test the display resolution.
3. Click OK to dismiss the Display Properties dialog box.
NOTE: See Chapter 3, “Using the Video Card,” for instructions on defining the display properties.
If you’re running Windows 2000
To verify the default system startup version:
1. From the operating system Start menu, go to Settings/Control Panel/System/Advanced.
2. Click Startup and Recovery.
3. On the Startup and Recover dialog box, verify that "Microsoft Windows 2000
Professional" is the listed as the Default operating system, then click OK.
4. Click OK to close the System Properties dialog box.