3DLABS Wildcat 4210 - Manual (Page 31)

24
Figure 10. Multiview In and Multiview Out ports
To confirm Multiview cables are detected:
1. From the system Start menu on the Slave workstation(s), go to Settings/Control
Panel/Display.
2. On the Display Properties dialog box, click the Settings tab.
3. If running Windows NT 4.0 skip to step 4. Under the Settings tab in Windows 2000, click
Advanced. The Advanced Properties dialog box displays.
4. Click the Intense3D Monitor Tab, then click Multiview.
5. The Input Cables will show as Detected under Multiview Information.
To enable Genlock features:
1. Connect the external timing source to the Genlock In port (see Figure 11) on the Master.
Figure 11. Genlock In port
2. From the system Start, go to Settings/Control Panel/Display.
3. On the Display Properties dialog box, click the Settings tab.