3DLABS Wildcat 4210 - Manual (Page 39)

32
NOTE: Refer to the Microsoft Windows NT 4.0 or Windows 2000 documentation and online Help for
more information on installing drivers and software application programs.
NOTE: If you are installing the Intense3D Wildcat 4210 driver, you must remove the current driver
prior to installing the update.
Reinstalling the video driver under Windows NT 4.0
To remove the existing Intense3D Wildcat 4210 driver:
1. Log on using an account that has administrative privileges.
2. From the operating system Start menu, go to Settings/Control Panel and double-click
Add/Remove Programs.
3. On the Add/Remove Programs Properties Install/Uninstall tab, highlight the Intense3D
Display Driver and click Add/Remove.
4. Click Yes when prompted to confirm the driver removal, and follow the prompts.
To reinstall the video driver:
1. Log on using an account that has administrative privileges.
2. Insert the delivery media into the appropriate device (for diskettes or CD).
3. From the operating system Start menu, go to Settings/Control Panel/Display and click the
Settings tab.
4. Click Display Type, then click Change.
5. In the Change Display dialog box, click Have Disk.
6. In the Install From Disk dialog box, type the path to the directory that contains the
delivery media.
7. In the Change Display dialog box, verify that the Wildcat 4210 driver is highlighted, then
click OK.
8. Click Yes when asked if you want to install a third-party driver. The files are copied from
the delivery media.
9. After the driver files are copied, a message that the driver successfully installed displays.
Click OK.
10. Click Close to exit the Display Type dialog box.
11. Click Close to exit the Display Properties dialog box.
12. When told that the workstation must be restarted for the new settings to take effect,
remove the diskette from the workstation’s floppy disk drive, if applicable. Click Yes to
restart the workstation.