3DLABS Wildcat 4210 - Manual (Page 32)

25
4. Under the Settings tab, click Advanced. The Advanced Properties dialog box displays.
5. Click the Intense3D Monitor Tab, then click Multiview.
6. Under Genlock Configuration, choose Enable (see Figure12).
7. Choose the signal source from the Source pull-down menu.
8. Select the Signal Edge Response, Signal Lock Rate, and Pixel Align Offset appropriate
for your application and hardware setup. Click Apply.
NOTE: Some monitors require custom timing file entries for Genlock to be properly maintained.
Please refer to the documentation delivered with your monitor for further information.
Figure 12. Multiview configuration dialog box.