3DLABS Wildcat 4210 - Manual (Page 45)

38
Figure 17. Connectors
Primary and Secondary DVI-I
The Primary and Secondary Digital Video Output ports use DVI-I receptacles with 29 signal contacts as
specified by the Digital Visual Interface Revision 1.0 specification. These ports support pixel rates up to
112MHz using the SII150A PanelLink device from Silicon Image. The ports are 100 percent compliant to
the DVI specification, and support digital and analog displays.
Genlock In
Genlock In, which uses a BNC connector, allows video timing to be synchronized to an external timing
source. The BNC connector is a 75 Ohm male connector and is used to connect to a 75 Ohm, coax cable
terminated with a female BNC connector. This connection provides a periodic signal to the display system
to lock vertical refresh rate.
Stereo Sync Out
The Stereo Sync Output port (female, 3-pin, mini-DIN connector) provides connection to a LCD shutter
glasses emitter module or to other stereo shutter devices.
Multiview In and Multiview Out
The Multiview In and Multiview Out ports allow “Multiview” support for frame locking and rate locking
of multiple workstations. The Multiview In and Multiview Out ports use shielded, RJ12 modular jack
connectors.