3DLABS Wildcat 4210 - Manual (Page 25)

18
3 Using the Video Card
This chapter contains instructions for configuring the video display and enabling the stereo display.
NOTE: If you ordered this video card with a system, it was configured for use prior to shipment. The
following instructions apply only if you purchased the card as an upgrade or add-on.
Configuring the Video Display
Once the drivers are installed properly in Windows NT 4.0, the Display Properties dialog box will have two
additional tabs: Intense3D Configuration and Intense3D Monitor. In Windows 2000, go to Display
Properties, Settings, and click Advanced to see the Intense3D tabs.
Intense3D Configuration Tab
To use the Intense3D Configuration tab:
1. Make sure you are logged into the non-VGA version of Windows NT 4.0 or Windows
2000. Refer to Windows NT 4.0 or Windows 2000 documentation or online Help for
instructions, if necessary.
2. Close any open applications.
3. From the operating system Start menu, go to Settings/Control Panel/Display. In Windows
NT 4.0, click the Intense3D Configuration tab if it is not already displayed. In Windows
2000 follow the same path; then click the Settings tab and then Advanced. Click the
Intense3D Configuration tab if it is not already displayed (see Figure 6).
4. On the Intense3D Configuration tab:
−
Click Hardware Info to view the current hardware settings.
−
Click View Config to view your current display configuration.
−
Click Config Wizard to activate a step-by-step interface that will help you modify
your current display configuration or create a new one. On the Wildcat Configuration
Wizard, click Next and follow the prompts to create a new configuration, or modify
or delete an existing one.