3DLABS Wildcat 4210 - Manual (Page 33)

26
Enabling the Dual Monitor Feature under Windows 2000
The Intense3D Wildcat 4210 features dual monitor support under Windows 2000. The dual monitor feature
allows two monitors to be connected to the card so the display area stretches across both monitors.
NOTE: This feature is available only with workstations running Windows 2000.
NOTE: Before enabling the dual monitor feature, connect the second monitor to the secondary DVI-I
port (see “Connecting the Monitor” for instructions).
To enable the dual monitor feature:
1. From the operating system Start menu, go to Settings/Control Panel/Display.
2. On the Display Properties dialog box, click the Settings tab.
3. Under the Settings tab, click Advanced. The Advanced Properties dialog box displays.
4. Click the Intense3D Configuration Tab, then next to Maximum Number of Displays,
select 2 (see Figure 13).
5. Click Apply.
6. Click Yes to shut down the system.
CAUTION: You must power off your system for the change to take effect.
7. Turn on power to the workstation. The primary monitor will display the startup sequence.
If either monitor’s Power On LED does not illuminate, or if the primary monitor does not
display the startup sequence, consult Chapter 4, “Troubleshooting.”