ADLINK PXIS-2719A - Manual (Page 36)

26 Getting Started
6. Repeat steps 1 to 5 to install additional PXI peripheral
modules.
2.3.3 Powering Up the System
The PXIS-2719A is equipped with a 100 VAC to 240 VAC univer-
sal power supply unit requiring no input voltage selection.
1. Connect one end of the supplied power cord to the
power inlet located at the rear side of the chassis.
2. Plug the other end of the AC power cord to a properly
grounded wall socket or power strip.
3. Press the standby power switch. The Power LED (blue)
lights up immediately
4. To power off the chassis, press the standby power
switch.
2.4 Rack Mounting
ADLINK provides hardware for optional installation of the PXIS-
2719A to a rack. The rack-mount kit flexibly recesses the PXIS-
2719A in the rack, accommodating external mechanical parts on
the front side, such as cables and mass interconnect modules.
NOTE: NOTE:
To improve efficiency of heat dissipation, after installing all PXI
modules, please install filler plates for any unused slots.