ADLINK PXIe-9529 - Manual (Page 22)

12 Getting Started
Inspect the carton and packaging for damage. Shipping and han-
dling could cause damage to the equipment inside. Make sure that
the equipment and its associated components have no damage
before installation.
X
Package Contents
X
PXIe-9529 dynamic signal acquisition module
X
ADLINK All-in-One compact disc
X
PXIe-9529 Quick Start Guide
If any of these items are missing or damaged, contact the dealer
2.2 Installing the Module
1. Turn off the PXI system/chassis and disconnect the
power cable from the power source.
2. Align the module edge with the module guide in the PXI
chassis.
3. Slide the module into the chassis until resistance is felt
from the PXI connector.
4. Push the ejector upwards and firmly seat the module into
the chassis.
5. Once the module is fully seated, a “click” can be heard
from the ejector latch.
6. Tighten the screw on the front panel.
7. Connect the power plug to a power source and turn on
the PXI system/chassis.
CAUTION:
The equipment must be protected from static discharge and
physical shock. Never remove any of the socketed parts
except at a static-free workstation. Use the anti-static bag
shipped with the product to handle the equipment and wear a
grounded wrist strap when servicing.
WARNING:
Do not install or apply power to equipment that is damaged or
missing components. Retain the shipping carton and packing
materials for inspection. Please contact your ADLINK
dealer/vendor immediately for assistance and obtain authoriza-
tion before returning any product.