ADLINK cPCI-6510 - Manual (Page 16)

2 Overview
1.2 Features
X
6U CompactPCI SBC in 4HP width form factor
X
µFC-BGA package Intel® Core™ i7 processor, up to 2.53GHz
X
Mobile Intel® BD82QM57 PCH (Platform Controller Hub)
X
Dual Channel DDR3 ECC SDRAM at 800 or 1066MHz sol-
dered onboard, up to 8GB
X
64-bit/66MHz CompactPCI Interface based on PCI specifica-
tions, 3.3V and 5V signaling
X
Supports operation in system slot as system master or in
peripheral slot with connectivity to CompactPCI bus* (optional
isolation from CompactPCI bus)
X
Dual PMC sites with 64-bit/133MHz PCI bus
X
Single XMC site with PCIe x8 lane (shared with inner PMC
site)
X
Up to two DVI ports for dual independent displays
X
Four PCIe Gigabit Ethernet ports, two at front, two for PICMG
2.16 or RTM
X
Onboard CompactFlash socket
X
2.5” SATA HDD direct connector onboard, occupies outer PMC
site
X
Up to -40°C to 80°C optional extended temperature support
X
RTM models available with multiple I/O options: SATA, HD
audio, COM, USB, Gigabit Ethernet, PS/2 KB/MS, PIM, SAS,
SCSI, CF, SD socket
X
Hardware RAID on SCSI, SAS interfaces supported (depen-
dent on RTM module)
NOTE: NOTE:
*See “Programming NT Mode EEPROM Map” on page 59 for
instructions on how to set the PCIe-to-PCI bridge on the
cPCI-6510 to NT-mode to allow operation in a peripheral slot.