ADLINK cPCI-6510 - Manual (Page 54)

40 Board Interfaces
COM1/Debug Switch (SW5)
Switch SW5 sets the RJ-45 COM1 serial port as a standard
RS-232 serial port or as an IPMI debugging port.
Table 4-18: COM1/Debug Switch Settings
Clear CMOS Switch (SW6)
Press switch SW6 to clear the CMOS and reset the CMOS val-
ues to default.
Front/Rear VGA Selection Switch (SW8)
Switch SW8 sets the VGA output to the front panel or to the
rear panel of the RTM. The default VGA output is set to front on
the cPCI-6510V and to rear on the cPCI-6510.
Table 4-19: Front/Rear VGA Selection Switch Settings
Mode 1 2 3 4
RS-232 COM port (default) ON ON OFF OFF
IPMI debugging port OFF OFF ON ON
Mode 1 2
Rear VGA output ON Not Used
Front VGA output OFF Not Used