ADLINK cBP-3062 - Manual (Page 34)

24
• Power Supply Unit
3.3 APS-925AX: 280 ATX Power Supply
3.3.1 Introductions
The APS-925AX switching power supply is ideal for use in ATX computers,
workstations or equivalent systems. This power supply can be installed with
the cPCI-PSF as a 3U CompactPCI power supply module.
3.3.2 Specifications
u AC Input Characteristics
AC Input voltage is switching automatically according to AC input
voltage. The acceptable input voltage range is as following table.
Voltage Frequency Minimum Maximum Input Current
115 VAC 47 ~ 63Hz 90 VAC 130 VAC 8.0A (300W)
230 VAC 47 ~ 63Hz 180 VAC 260 VAC 4.0A (300W)
u
DC Output Characteristics
Voltage +5V +3.3V +12V -5V -12V 5VSB
Max. Load 30A 15A 15A 1.0A 1.0A 1.2A
Rated Load 25A 8A 10A 0.5A 0.5A 0.72A
Min. Load 2A 0 0.1A 0 0 0
300W
Max.Power Combined
150W
120W 2.5W 6W 4W
At factory, all outputs in 60% rated load condition , the +5V output is
set to between 4.80V and 5.20V. The other outputs are checked to be
within the specified voltage accuracy range.
u
Output power
The total DC continuous power shall be kept within 280W at ambient
temperature of 40°C below, and input voltage at 115VDC or 230VAC.
The maximum combined output power on the 3V3 and 5V rails is
150W. The maximum outputs load is not allowed for more then 30
seconds.
u
Ripple & Noise
The peak to peak ripple and noise for +5V, +3.3V output are less than
50mV, and for the other output are less than 100mV at rated load.
Measuring is done by 15MHz bandwidth limited oscilloscope and
terminated each output with a 0.47 µF capacitor.
u