ADLINK Starter Kit - nanoX - Manual (Page 27)

2.5 LVDS Output using HannStar Flat Panel Display
To use the HannStar 10.1” LVDS flat panel display included with the nanoX-BASE Starter Kit,
follow the instructions below.
Install Flat Panel Display Required items
Step 1
Set the nanoX-BASE Panel Power Jumper (JP3) is set
to +3.3V (short 1-2) and the Backlight Power Jumper
(JP4) is set to +5V (short 2-3) as shown below
Step 2
Connect the JAE FI-Series end of the LVDS panel cable
(P/N: 30-20243-2000) to the LVDS flat panel display as
shown
NanoX Starter Kit – Quick Start Guide Page 27