Bios programming, Bios recovery connector (x9), 11 bios programming – ADLINK CM3-GF User Manual
Page 44
Advertising
TME-104P-CMx-GF-1V7
Rev 1.7
36 (81)
3.11 BIOS Programming
To recover from special BIOS errors, a Dediprog SF-100 programmer can be used. This is a special hardware
unit that can be attached to the BIOS programming connector. In most cases this is not necessary because of a
second BIOS chip (Recovery BIOS) on board. The SMC automatically switches to the second chip if the system
BIOS gets corrupted.
BIOS Recovery Connector (X9)
Connector type: Hirose DF13 8-pin
Pin
Signal
1
+3.3V
2
SPI_CS1#
3
SPI_CS2#
4
SPI_DATAIN
5
SPI_DATAOUT
6
GND
7
SPI_CLK
8
GND
Caution
The maximum current on the supply pin is 0.3A.
Advertising
This manual is related to the following products: