Video (ttl/vga) interface, Table 3-12, Video interface pin/signal descriptions (j11) – ADLINK CoreModule 430 User Manual

Page 32

Advertising
background image

Chapter 3

Hardware

26

Reference Manual

CoreModule 430

Video (TTL/VGA) Interface

The Volari Z9s graphics controller provides two graphics display ports for video signals to flat panel

displays and traditional glass CRT monitors. The features are listed below:

Enhanced 2D Graphics Controller

Full BitBLT Implementation for all 256 Raster Operations Defined for Windows

Supports 4 Transparent BLT Modes

Bitmap Transparency

Pattern Transparency

Source Transparency

Destination Transparency

Rectangle Clipping

Fast Line Draw Engine with styled pattern

Fast Rectangle Fill Engine

256MB frame buffer with linear addressing

64x64x2 bit-mapped mono hardware cursor

VGA Output (DB15)

Supports 135 MHz triple RAMDACs for 1280 x 1024 x 75 Hz display

Supports 24-bit pixel depth

Supports interlaced or non-interlaced output

TTL Output

Conforms with VESA Flat Panel Display Interface FPDI-1B

Supports up to 1600x1200 pixel display resolutions

Uses Internal CRT Controller for display modes settings

Supports 12-, 18-, and dual 12-bit Interface (1 pixel/clock)

Table 3-12

describes the pin signals of the Video interface, which uses a 44-pin, right-angle header with 2

rows, odd/even sequence (1, 2), and 0.079" (2mm) pitch.

Table 3-12. Video Interface Pin/Signal Descriptions (J11)

Pin #

Signal

Description

1

TFTDCLK TFT Shift Clock – This clock signal provides the timing for transferring digital

pixel data.

2

TFTDE

TFT Data Enable – This signal indicates valid data on any of the FP [23:0] lines.

3

TFTLP

TFT Line Pulse – This signal is the digital monitor equivalent of HSYNC.

4

TFTFrame

TFT Frame Marker – This signal is the TFT monitor equivalent of VSYNC.

5

GND

Ground

6

GND

Ground

7

NC

Not connected (FP0 = Panel Data 0)

8

NC

Not connected (FP1 = Panel Data 1)

9

FP2

Panel Data 2 – These pins (0 to 23) provides digital pixel data output signals.

10

FP3

Panel Data 3 – Refer to pin 9, FP2, for more information.

11

FP4

Panel Data 4 – Refer to pin 9, FP2, for more information.

Advertising