ADLINK CoreModule 430 - Manual (Page 47)

Chapter 4 BIOS Setup
CoreModule 430 Reference Manual 41
BIOS Security Setup Screen
Figure 4-5. BIOS Security Setup Screen
• Supervisor Password – [Not Installed]
• User Password – [Not Installed]
• Change Supervisor Password
a. Select Change Supervisor Password from the Security Setup menu.
b. Press <Enter> to access the pop-up entry field, Enter New Password.
c. Type the password and press <Enter> again.
The screen will not display the password as you type.
d. Re-type the password when prompted by the pop-up entry field and press <Enter> again.
If the password is not confirmed when you re-type it, an error message will appear. The password is
stored in NVRAM if you have successfully entered the password.
• Change User Password
a. Select Change User Password from the Security Setup menu.
b. Press <Enter> to access the pop-up entry field, Enter New Password.
c. Type the password and press <Enter> again.
The screen will not display the password as you type.
d. Re-type the password when prompted by the pop-up entry field and press <Enter> again.
If the password is not confirmed when you re-type it, an error message will appear. The password is
stored in NVRAM if you have successfully entered the password.
• Boot Sector Virus Protection – [Disabled; Enabled]
BIOS Setup Utility
Security Settings
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
v02.xx (C) Copyright 1985-20xx, American Megatrends, Inc.
Supervisor Password : Not installed
User Password :
Not installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection [Disabled]
Main Advanced PCIPnP Boot Security Chipset Exit
CM430_BIOS_SecurityScreen_a