Power interface, Table 3-16, Power interface pin/signals (j7) – ADLINK CoreModule 430 User Manual
Page 37
Chapter 3
Hardware
CoreModule 430
Reference Manual
31
Power Interface
The CoreModule 430 requires one +5 volt DC power source. If the +5VDC power drops below ~4.65V, a
low voltage reset is triggered, resetting the system.
The power input header (J7) supplies the following voltages and ground directly to the module:
•
5.0VDC +/- 5% @ 1.35 Amps
describes the pin signals of the Power interface, which uses a 10-pin, right-angle header with 2
rows, odd/even sequence (1, 2), and 0.100" (2.54mm) pitch.
Note: The shaded table cells denote power or ground.
Table 3-16. Power Interface Pin/Signals (J7)
Pin
Signal
Descriptions
1
GND Ground
2
+5V
+5 Volts
3
Key/GND
Key Pin on connector/Grounded on board
4
+12V
+12 volts routed to PC/104
5
GND
Ground
6
NC
Not connected
7
GND
Ground
8
+5V
+5 Volts
9
GND
Ground
10
+5V
+5 Volts