Bonaire Navigator Controller - Manual (Page 12)

Multi-Appliance Navigator Control
Navigator Control Page 12
Navigating the Controls
12. CHILD LOCK
Your Navigator Controller provides a special child lock function to protect
the current operation or program. To activate CHILD LOCK function at
any time,
1. Press and hold the HEAT/COOL and MODE buttons.
2. The child lock is enabled and the lock icon will appear on the
display. Any key press will be ignored and the error icon will
flash.
3. Press and hold the HEAT/COOL and MODE buttons again to
disable the child lock.
13. PAIRING YOUR NAVIGATOR CONTROLLER (RF Only)
Note that this is normally undertaken by the installer.
The BONAIRE Navigator Controller and transceiver does not
have any pairing information when they are delivered from the
factory.
The RF handset must be “paired” to it’s transceiver (antenna). On
the first power up, the transceiver will request to join with
Navigator Controller for period of a 30 min window and it will flash
a green light. If it does not join within that time, it will join the next
time the unit is powered up.
To put the Navigator Control into pairing mode -
1. Press & hold the ENTER button for 3 seconds.
2. Press the Heat/Cool, Mode & Setup buttons in sequence.
The display will flash the “
PAir ”.
3. After few seconds the display will show the controller number.
For example “
ro 22 ”. Press the ENTER button to pair with
transceiver.
NOTE: Bars on the display will indicate signal strength.
4. Press the ON/OFF button to go back to the main display.
The RF handset and the transceiver are now paired together ready
for use.