Bonaire Navigator Controller - Manual (Page 9)

Multi-Appliance Navigator Control
Navigator Control Page 9
Navigating the Controls
SETUP
•
The SETUP button is used to configure the Navigator Controller in
either the ON or OFF condition. It allows time setting, program and
advanced setup. The advanced setup will only be allowed if the
Navigator Controller is in the OFF condition.
ENTER
•
Press and release the ENTER button to save settings when in SET
TIME, PROGRAM mode and ZONE setting.
•
Press and release the ENTER button to immediately send
instructions.
6. THE LCD DISPLAY
The Navigator Controller display shows different information depending on
the functions in use. The Navigator Controller usually shows only those
items relevant to the appliances you have installed.
7. BACKLIGHT
The Navigator Controller provides a BLUE and ORANGE backlight. The
blue backlight is illuminated for cooling appliances and the orange
backlight is illuminated for heating appliances. To adjust the backlight
level,
1. Press and hold the SETUP button until the “ LitE ” appears on
the display.
2. Press the or button to decrease or increase the
backlight level.
3. Press the ENTER button to select the backlight level adjustment.
8. QUICK START
To give you time to choose your settings the Navigator Controller pauses
15 seconds and then sends its signal to your Heater/Cooler. Watch for the
transmit symbol on the screen. This means that the signal has
been sent. (RF only)
Your Navigator Controller is designed to automatically detect the
appliances connected. Controller options not required for your connected