Bonaire Navigator Controller - Manual (Page 19)

Multi-Appliance Navigator Control
Navigator Control Page 19
Ducted Gas Central Heating
BOOST MODE
The BOOST mode operates the heater at maximum power level if the
room temperature is below the set temperature. The Navigator Controller
turns off the unit when the set temperature is reached. The Navigator
Controller turns the unit back on when room temperature drops again. To
operate BOOST mode,
1. Turn the Navigator Controller ON by pressing the ON/OFF button.
2. Press the MODE button until the Boost icon appears on the display
and press the ENTER button to select the Boost mode.
3. Press the UP/DOWN button to decrease or increase the set
temperature. You can set the temperature from 10°C to 32°C.
FAN MODE
In FAN mode the heater operates the fan only to circulate air. In this
mode, the fan speed can be adjusted to the desired level. To operate the
FAN mode,
1. Turn the Navigator Controller ON by pressing the ON/OFF button.
2. Press the MODE button until the FAN icon appears on the display
and press the ENTER button to select.
3. Press the UP/DOWN button to decrease or increase the fan speed.
You can set the fan speed up to 8 levels.
ZONING
The Navigator Controller is capable of controlling up to 8 switched zones
and one unswitched zone. If more zone control is required than the
standard 4 zones which is supplied with a 4 or 5 star heater, then a zone
extension kit is available. This will increase zone control from 4 to 8 with
one unswitched zone. Selecting ZONE only applies if your home is fitted
with optional motorised ductwork dampers (please consult your installer)
that allow opening or closing of each section of ducting.* Not available on
3 star units.
The Navigator Controller will show only installed zones. If no dampers are
fitted and the installer correctly configures the heater, no zones will be
shown and zone setup cannot be selected.
In homes with more than one zone, at least one zone must be open at all
times. The default zone is 1 if no other is selected.
To set the open or closed status of a ZONE:
1. Press and release the ZONE button. ZONE 1 (or the current open
zone) will flash.
2. Press the or button to select the zone you wish to control.