Bonaire Navigator Controller - Manual (Page 13)

Multi-Appliance Navigator Control
Navigator Control Page 13
Navigating the Controls
14. RESETTING THE NAVIGATOR CONTROLLER
CAUTION! This will reset the controller to it’s factory default settings
and so after a reset, the control may need to be set up again to suit
your installation requirements (depending on how your system was
first set up).
To reset the Navigator Controller to the default setting,
1. Press & hold the ON/OFF button for 3 seconds.
2. Then press the UP, DOWN and SETUP buttons in sequence.
3. After few seconds, the display will flash “ butt ” followed by
“ FAIL ”.
4. When the Navigator Controller has finished resetting, the display
will flash default settings as shown.