Bonaire Navigator Controller - Manual (Page 32)

Multi-Appliance Navigator Control
Navigator Control
Page 32
Ducted Evaporative Air Conditioning
BOOST MODE
In BOOST mode the cooler runs both the pump and the fan at maximum
output level. To use the BOOST mode,
•
Press the MODE button until the BOOST icon appears on the
display and press the ENTER button to select the Boost mode.
All the 8 bars are displayed indicating full fan speed.
•
Press the MODE button again to change to a different mode.
FAN MODE
The Navigator Controller provides 8 levels of Fan Only operation. The
cooler runs the fan only with the output level set directly by the user (The
unit will not cool in the FAN mode). To use the Fan mode
•
Turn the Navigator Controller ON by pressing the ON/OFF
button.
•
Press the MODE button until the Fan icon appears on the display
and press the ENTER button to select the Fan mode.
•
Press the or button to decrease or increase the fan
speed. You can set the fan speed up to 8 levels.
27. PROGRAMMED OPERATION
Your Navigator Controller can only allow the START/STOP time to be set
for Evaporative Coolers. If your Navigator Controller is ON then you can
set only the OFF time and if your Navigator Controller is OFF then you can
only set the ON time for the Evaporative Cooler. The programmed
operation is cancelled by pressing the ON/OFF button. To setup the
program,
1. Press the SETUP button. Clock, Program & Advanced (OFF
state only) icons will display on the screen. Clock is flashing.
2. Press the or button to select the Program and then
press the ENTER button.
3. The HOUR icon will flash. Press the or button to set
START/STOP hours and press the ENTER button to set the
HOUR.
4. The MINUTE icon will flash. Press the or button to set
START/STOP and press the ENTER button to set the MINUTES.
5. Press the SETUP button to go to the main display at any time.
Now your program has now been set. The Navigator Controller will turn
ON/OFF your Cooler according to the program.