Bonaire Navigator Controller - Manual (Page 18)

Multi-Appliance Navigator Control
Navigator Control Page 18
Ducted Gas Central Heating
•
When the room temperature reaches the set temperature the
central heater will shut down.
•
When the room temperature has dropped approximately 0.5º
below the set temperature the unit will restart.
•
As your activities vary, you may find you need different
temperature settings, e.g. a temperature comfortable for
sitting is usually too warm compared to when you’re moving
about.
•
For economical operation, set a low SET TEMP during the
day when you are active, or use the ECONOMY mode.
Switch the Navigator Controller OFF when asleep and ON
again when awake. These cost saving functions can be
programmed to operate automatically (see Programmed
Control).
7. Press the ON/OFF button to switch the heater OFF.
8. The Navigator Controller remembers your SET TEMP setting and
uses it the next time you turn it ON.
ECONOMY
MODE
The ECONOMY mode operates the heater at the lowest power level if the
room temperature is below the set temperature. The Navigator Controller
turns off the unit when the set temperature is reached and then back on
when the room temperature drops again. To operate the ECONOMY
mode,
1. Turn the Navigator Controller ON by pressing the ON/OFF
button.
2. Press the MODE button until the Economy icon appears on the
display and press the ENTER button to select.
3. Press the or buttons to decrease or increase the set
temperature. You can set the temperature from 10°C to 32°C.