Bonaire Reverse Cycle - Manual (Page 17)

Multi-Appliance Comfort Control
Page 17
Ducted Reverse Cycle
USING YOUR COMFORT CONTROLLER – GENERAL OPERATION
There is 2 ways to operate your Comfort Control. You can use MANUAL where you select the operating
modes or you can use the AUTO and program the operation modes to happen automatically.
C OOLING M ODE - M ANUAL
1. Turn the comfort control ON, press and release the ON/OFF
button. When fitted to a Ducted Reverse Cycle system the control
will default to HEATCOOL.
NOTE: Your Comfort Controller is designed to automatically
detect the appliances you have installed, once coded. Controller
options not required for your appliances will usually not be visible
on your Comfort Control display. So don't worry if you don't see all
the menu items listed in this book.
2. Press the MANUAL/AUTO button until MANUAL is displayed.
3. Press the HEAT/COOL/FRESH AIR button until COOL appears at
the top of the display.
4. Press & hold the ▼ or ▲ buttons to decrease or increase SET
TEMP or, press & release buttons to change the SET TEMP one
degree at a time. Set the temperature to your desired
temperature.
NOTE: The set temperature must be below the room temperature
before the system will begin cooling operation.
5. The Comfort Control measures the room temperature using a
thermostat inside its case. When the room temperature is warmer
than the SET TEMP the system will start.
NOTE: For safety operation there is up to a 3 minute delay before
the compressor will start. This safety timer will begin at every
compressor shutdown and when the main switch is first turned on.
6. The indoor fan will operate at the system selected speed; this can
not be changed by the user and has been selected by your
installer to provide you will the most optimum performance for
your system design.
NOTE: The default fan speed for manual operation is High speed.
7. Press the ON/OFF button to switch the air conditioner OFF. OFF
will appear on the display.
8. The Comfort Control remembers your SET TEMP and operating
setting and uses it next time you turn it ON.