Bonaire Reverse Cycle - Manual (Page 22)

Multi-Appliance Comfort Control
Page 22
Ducted Reverse Cycle
A
UTO
– P
ROGRAM
M
ODE
Auto mode is where the Comfort control automatically
operates your unit according to your program settings. The
default sequence is as per the chart. To set your program,
see next section Programming Your Comfort Control.
To operate your unit in AUTO mode, press the
MANUAL/AUTO button, the display will show AUTO (if
operating in MANUAL). The unit will now turn on and off at
specific times and will change operational functions as
programmed.
P
ROGRAMMING
Y
OUR
C
OMFORT
C
ONTROL
Programming your Comfort Control will provide you with energy and
time savings not to mention the comfort of set and forget air
conditioning. Your air conditioning system will only operate when you
need it, and at your chosen comfort levels.
Determine your most comfortable settings, program them and let your
Comfort Control do the rest automatically.
Programming Sequence
If you've never programmed your Comfort Controller before (or it’s been
a while) remember it's easiest to program the whole week to the same
settings (by selecting the whole week MON TUE WED THU FRI SAT
SUN day choice) and then program variations for particular days or the
weekend as you become more familiar with programming.
If the Controller exits program mode it may be because you've paused
longer than about 15 seconds to make your next choice. All the settings
you've made up to then will be saved. Just switch back to program
mode, scroll through your settings using the ENTER key and carry on
from where you left off.
The following is the programming sequence once the control is turned
on:-
1. To Start Program: Press the SET TIME/PROGRAM button.
PROGRAM 1 and the current day will flash.
2. Selecting the Days / Day Group: Press the ▼ or ▲ arrows to
select the day or day group to be modified. Options are: ‘Single
Day’, ‘MON TUE WED THU FRI’ or ‘SAT SUN’ or ‘MON TUE
WED THU FRI SAT SUN’. Press ENTER to complete the
selection
3. Turning the unit On or Off: Press the ON/OFF button to turn the
unit ON or OFF. At this point the control display will be ON or OFF
and the timer hour number will be flashing.
4. Selecting the Operating Mode: if programmed ON: You can now
select whether you would like your air conditioning system to
operate in heating only or cooling only or heating & cooling
(changeover) modes. Press the HEAT/COOL/FRESH AIR button
to select the operating mode you require, if the mode is already
selected proceed to the next step.