Bonaire Reverse Cycle - Manual (Page 19)

Multi-Appliance Comfort Control
Page 19
Ducted Reverse Cycle
H EATING & C OOLING A UTO -C HANGEOVER M ODE - M ANUAL
1. Turn the comfort control ON, press and release the ON/OFF
button. When fitted to a Ducted Reverse Cycle system the control
will default to HEATCOOL.
NOTE: Your Comfort Controller is designed to automatically
detect the appliances you have installed, once coded. Controller
options not required for your appliances will usually not be visible
on your Comfort Control display. So don't worry if you don't see all
the menu items listed in this book.
2. Press the MANUAL/AUTO button until MANUAL is displayed.
3. Press the HEAT/COOL/FRESH AIR button until HEATCOOL
appears at the top of the display.
4. Press & hold the ▼ or ▲ buttons to decrease or increase SET
TEMP or, press & release buttons to change the SET TEMP one
degree at a time. Set the temperature to your desired
temperature.
NOTE: Your system will select the best operating mode of either
heating or cooling to achieve the selected SET TEMP.
5. The Comfort Control measures the room temperature using a
thermostat inside its case. When the room temperature is cooler
or warmer than the SET TEMP the system will start in either
heating or cooling respectively.
NOTE: 1) For safety operation there is up to a 3 minute delay
before the compressor will start. This safety timer will begin at
every compressor shutdown and when the main switch is first
turned on. 2) To avoid short cycling between each heating and
cooling operation the system will determine the minimum time
delay required before auto-changing from heating to cooling
modes or vise-versa.
6. The indoor fan will operate at the system selected speed; this can
not be changed by the user and has been selected by your
installer to provide you will the most optimum performance for
your system design.
NOTES: 1) The default fan speed for manual operation is High
speed. 2) Your Bonaire Ducted Reverse Cycle system
incorporates Bonaire’s unique SOFT HEAT function. This function
prevents the circulation of cold air while the system is in heating
mode. The indoor fan will automatically cycle on & off at startup to
allow the indoor heat exchange to heat up. Once the indoor heat
exchanger has reached the optimum temperature the indoor fan
will start and cycle off if the indoor coil temperature drops below
25°C (speak with your dealer if you wish to disable this option).
7. Press the ON/OFF button to switch the air conditioner OFF. OFF
will appear on the display.
8. The Comfort Control remembers your SET TEMP and operating
setting and uses it next time you turn it ON.