EXFO FTB-8100 Series Transport Blazer for FTB-500 - Manual (Page 123)

Creating and Starting a Test Case
SONET/SDH Application 109
Typical Test Cases
2. Interface connector selection:
2a. From the data path
selector, press the
Optical interface connector. Optical is automatically selected
when OTN Intrusive check box is selected.
2b. Select Framed or Unframed. Framed is
automatically selected in Through or
decoupled mode.
2c. Press Next.
3. Interface selection and configuration:
3a. Press the desired interface: OTU1e (11.049G),
OTU2e (11.096G), OTU1f (11.270G) or
OTU2f (11.317G).
3b. When Unframed is selected, press Next and go to step 6.
3c. Select the Enable FEC and Enable Scrambler check boxes if
needed. Refer to FEC TX on page 154 and OTU TX on page 157 for
more information.
3d. Press Next.
4. Select ODU TCM (TCM1 to TCM6) layers as required
and press Next or Finish.