EXFO FTB-8100 Series Transport Blazer for FTB-500 - Manual (Page 527)

Common Tabs
SONET/SDH Application 513
Client Offset TX
Client Offset TX
Note: Available with ODUflex CBR and Gb Ethernet client. Not available in
Through mode.
For ODUflex CBR, press TEST, BERT, and Client Offset.
For Gb Ethernet, press TEST, Gb Ethernet, and Client Offset.
Frequency
³
Frequency Offset (ppm): Allows entering a positive or a negative
client frequency offset in ppm. The default setting is 0.
On/Off button: Allows enabling the frequency offset generation. This
setting is disabled (Off) by default.
³
Actual Frequency (bps): Indicates the frequency (Nominal fequency
+ port frequency offset + client frequency offset) used for
transmission fo the client signal. Refer to Frequency on page 149 for the
port frequency offset.
BERT
Gb Ethernet