EXFO FTB-8100 Series Transport Blazer for FTB-500 User Manual
Page 124
Creating and Starting a Test Case
110
FTB-8100 Series Transport Blazer
Typical Test Cases
5. For OTU1e/OTU2e, if required, select 10G Ethernet
as the mapping and set the Ethernet parameters.
Refer to Configuration on page 393 for more
information.
The 10G Ethernet link status is available from the
Tree tab.
5a. Press Next or Finish.
6. Pattern Configuration:
6a. Set the pattern parameters. Refer to Pattern TX
on page 405 and Pattern RX on page 409 for
more information.
7. Press Finish to complete the test setup. The Grid tab
closes and automatically switch to the Alarm summary tab.
8. For additional configuration parameters and results, refer to Summary
Tabs on page 125, Port Tabs on page 137, OTN Tabs on page 153,
Ethernet Tabs on page 393 (OTU1e/OTU2e only), BERT Tabs on
page 405, and Advanced Tabs on page 411. For Unframed mode, only
Summary, Port, and BERT tabs are available.
9. Press the Start button to start the test. Refer to Global Test Status and
Controls on page 35 for more information on test management.