Generalmusic wk1000 - Manual (Page 56)

PAGE PAGE
PAGE PAGE
CURSOR
owners manual wk1000
the user styles Page50
All empty User Styles contain a default Performance. The default performance has
the following sounds assigned to the accompaniment tracks (see the table).
THE USER STYLE PERFORMANCE
Track Sound name Pr. Change
Drums Stand1 112
Bass Finger 33
Acc1 Piano1 00
Acc2 SteelGtr 25
Acc3 Strings 48
It is NOT possible to recall a Style User Performance with the PERFORMANCE RECALL button, as it happens
with Performances in RealTime, Song/Style and Song modes. Each User Style is associated to a single User
Style Performance which is stored in the current Style User location only and not in other locations.
HOW TO PROGRAM A USER STYLE PERFORMANCE
A User Style Performance can be programmed in Style User Record mode only. Follow the instructions given
in the Performance chapter to modify the sounds and the values of the tracks. Make sure that the track name
appears above the Program change number (press the corresponding Function key twice). Once you have
programmed the User Style Performance, press and hold the PERF STORE key for one second. Press ENTER
to confi rm. The modifi cations are directly stored in the User Style location. Follow the recording procedure
as described.
TO ASSIGN A NAME TO A USER STYLE
A proper name can be assigned to each USER style
IMPORTANT: enter the RECORD MODE to assign a name to the Style. Press the PAGE button to select the Performance
Name page.
1 Select a USER STYLE and press the REC button to switch to RECORD MODE
2 Press the PAGE button to select the PERFORMANCE NAME page
3
the alpha-numeric function is set automatically. You can now enter the
User Style name, using the keyboard keys
4 Press and hold the PERF STORE button. Press ENTER to confi rm
The USER STYLE name is now saved.
You may decide to change a Sound during the recording. In that case the Sequencer will record the cor-
responding Program Change number to the relative track. When playing the Style back , the track (or the
tracks) containing the Sound that has been changed, will play the fi rst cycle of the Riff with the original
Sound and will change to the second Sound exactly as recorded, that is, the second Sound will be included
from the second cycle and all the subsequent ones. It will not be possible therefore to listen to the original
sound, unless the Style is stopped and restarted. To avoid this condition, it is advisable to record a Program
Change to the original Sound again, just before the end of the fi rst cycle of the Riff. In this way, all the suc-
cessive cycles of the Riff will start with the fi rst Sound selected. The best results are obtained when modify-
ing Riffs that are 4 bars long or more.
All controls generated by hardware devices (Pitch bend, Modulation), or by the optional pedals connected
to wk1000 rear-panel sockets can be recorded to the relative track. To record Volume section messages,
use the optional Volume Pedal, that can be programmed in the Volume section in the General Menu.
TO RECORD PROGRAM CHANGE
RECORDING COMMANDS