Generalmusic wk1000 - Manual (Page 66)

PAGE PAGE
PAGE PAGE
CURSOR
owners manual wk1000
the midi/general mode Page60
The CHANNEL LOCK function locks the current Performance setting. Before using this function you should
set the CHNLOCK function to ON status, then modify the setting of the MIDI channels. This is the only way to
apply the MIDI channel setting to the entire instrument. Use the TEMPO/DATA to set the function ON or OFF.
CHNLOCK (ON/OFF)
DUMP function transmits all data from wk1000 internal memory via MIDI: this is a further possibility
to safeguard valuable data. Proceed as follows to dump data to an external MIDI data fi ler (computer,
sequencer, etc.).
The last setting saved of the instrument is maintained in the memory. Even switching off the keyboard, is provided that the fi rst
Performance, which is the one on which wk1000 sets by default upon turning on, has been saved to Store Performance.
•MIDI DUMP
Once fi nished press twice the ENTER button 4
Start the Recording procedure in the external device 3
Use the PAGE buttons to select the DUMP page. Now select the type of data you wish to
transfer (ALL, SEQ, PERF) using the TEMPO/DATA buttons 2
Connect wk1000 MIDI OUT port to the MIDI IN of the external device 1
To properly receive the MIDI dump data, connect the transmitting external device MIDI OUT to the wk1000
MIDI IN. Enable the MIDI data transmission, the MIDI dump data reception is automatically set.
MIDI DUMP SAVED DATA RECEPTION
This function allows you to restore the wk1000 factory default. The different instrument memory sections:
performance (PFM), sequencer (SEQ) or ALL can be indepenently restored. Press TEMPO/DATA to select the
memory area to inizialize and twice the ENTER button.
INIZIALIZE ALL
The last page of the MIDI/GENERAL menu shows the date of the latest operating release system installed
on board. Press ESCAPE to exit the current mode.
OPERATING SYTEM RELEASE DATE: EL XX_XX_XX