Generalmusic wk1000 - Manual (Page 57)

PAGE
PAGE
CURSOR CURSOR
PAGE
PAGE
CURSOR CURSOR
PAGE
PAGE
CURSOR CURSOR
owners manual wk1000
Page51 the digital signal processor
THE DIGITAL SIGNAL PROCESSOR
1 Press and the REV/CHO button for a few seconds
When it is active (the LED indicator is ON), the current Performance is processed from
the type of effect assigned both to the Reverb and to the Chorus unit of the DSP. The
overall processed sounds can be heard over the internal speakers and from the LEFT e
RIGHT outputs. When it is not active (the LED is OFF) , the sound is not processed by the
DSP and no effect is given.
The wk1000 allows you to process Performances (Style/RealTime, Song Style e Song Performance) through
the on-board multi-effect processor and to make the overall sound more realistic. The Digital Signal Proc-
essor is made by two units that process the Performances with Reverb and Modulation/Delay effects. Each
section has independent effects Send control to regulate the effect volume level in the current Performance.
The DSP control buttons are located in the UTILITY area.
REV/CHO
If a different Performance is selected, or if the same Performance is selected
again before saving the changes, the new effect settings will be lost and the
Performance will be restored to the previous setting.
TO ASSIGN THE EFFECTS
The way to assign effects to the current Performance is identicaI, no matter what the selected mode is
(Style/Real Time, Song Style, Song).
HOW TO SELECT THE TYPE OF EFFECT
The effect currently assigned to the Performance is indicated in the display.
2
Use CURSOR to move and the TEMPO/DATA buttons to assign a different
effect
You can scroll 22 different types of effect available for each DSP unit. The same
effect can be selected from both the DSP units. The same effect can be selected
from both the DSP units
To control the general effect VOLUME, move with the CURSOR button to the
volume page and modify its value using the TEMPO/DATA buttons.
The selected effects have now been assigned to the current Performance.
3 To exit the effect function, use the CURSOR button or press ESCAPE.
4
Press and hold STORE PERFORMANCE for a few seconds. Press ENTER to save
the changes in the current Performance.
You can disable the effects assigned to the current Performance at any time by pressing the REV/CHO but-
ton you will either enable (led ON) ) or disable (led OFF OFF) the DSP.
DISABLING THE EFFECTS