Dukane iQ Series ULTRASONIC POWER SUPPLY AL ISO 9001:2008 - Manual (Page 13)

Page 
Section 2 – Health and Safety
Dukane Manual Part No. 403-583-00
General Considerations
Please observe these health and safety recommendations for
safe, efficient, and injury-free operation of your equipment.
In this manual, the term system refers to a complete group
of components associated with the welding of plastic or
metal parts, also known as an ultrasonic assembly system.
A typical system consists of a generator and/or ultrasonic
process controller, start and stop switches, power controls,
connecting cables, and the probe assembly which includes
the transducer, booster, horn and replaceable horn tip.
Proper Installation - Operate system components only
after they are properly installed and checked.
No Unauthorized Modifications - Do not modify your
system in any way unless authorized to do so by the man-
ufacturer. Unauthorized modifications may cause injury
to the operator and/or equipment damage. In addition,
unauthorized modifications will void the equipment war-
ranty.
Keep the Cover On - Do not remove any equipment cov-
er unless specifically directed to do so by the manufactur-
er. The generator produces hazardous electrical voltages
which could cause injury.
Grounded Electrical Power - Operate this equipment
only with a properly grounded electrical connection.
(See Page 8 for grounding information.)
Comply with Regulations - You may be required to add
accessories to bring the system into compliance with ap-
plicable OSHA regulations for noise exposure.
Plastics Health Notice
Before using any ultrasonic welding system, be sure you
are familiar with OSHA regulations from the U.S. Depart-
ment of Labor about the particular type of plastic(s) you
are using.
When plastic materials are being processed, they may emit
fumes and/or gases that could be hazardous. Make sure
you have adequate ventilation whenever these plastics are
processed.
CAUTION
Parts being joined ultrasoni-
cally sometimes vibrate at
audible frequencies. Wear
ear protection to reduce
annoying or uncomfortable
sounds. In addition, sound ab-
sorbing materials, enclosures
or sound deflectors may be in-
stalled to reduce the noise level.
WARNING
Never operate the gen-
erator with the cover
off . This is an unsafe
practice and may cause
injury .
