Glow-worm 30ci Plus - Manual (Page 20)

20 4000123944-2
10 Horizontal Telescopic Rear Flue Installation
Pho 087
Diagram 10.3
10.1 Horizontal Telescopic Rear flue -
kit No. A2018000, refer to diagram 10.1
Suitable for installations that require a flue length "L" 193 -
510mm. For flue lengths less than 328mm the duct will need to
be cut, see diagram 10.2.
To make a neat finish to the flue outlet, a flue collar kit, part No.
900850, with instructions, is available, see diagram 10.3.
Flue and Air Duct preparation
Extend the telescopic flue to the required length, making sure
that the minimum overlap is no less than 25mm, see diagram
10.2, and that the flue terminal projects 15mm minimum beyond
the wall face.
Carefully drill though air duct pilot hole and secure with self
tapping screw provided in fittings pack.
Seal the joint with the tape provided.
Fit the self adhesive foam seal provided in the flue pack around
the air duct at a position such that it will be in the wall, shown in
diagram 10.2.
Make sure that the ductings do not slope down towards the
boiler.
Push the flue assembly into and through the hole such that it is
within the wall, and does not stick out into the room. Do not push
the flue assembly too far into the hole as it has to be pulled back
into the boiler and secured.
Now continue with Fixing Jig and system connections, see
section 8, then complete the flue installation as described in the
following paragraphs 10.2 to 10.6.
10.2 Sealed chamber cover
• Unscrew and remove the two retaining screws from the sealed
chamber cover, see diagram 10.4
• Lift cover up and off pins on top of boiler.
12060
The flue kit No. A2018000 comprises:
- Telescopic flue assembly ..................................... A
- Sensing tube cap (fitted) ...................................... B
- Gasket ..................................................................... C
- Spigot ...................................................................... D
- Tape ......................................................................... E
- Foam seal ................................................................ F
- Screws 6 off ............................................................ G
- Restrictor flue hood outlet ................................... H
Diagram 10.1 Horizontal Rear Telescopic flue kit
A
B
C
E
D
F
H
G
Diagram 10.2
"L" FLUE LENGTH =
"Y" WALL THICKNESS + 133mm
12007
NOTE: If it is necessary to cut the "flue length", make sure
that the overlaps are as follows:- air duct = 25mm
flue duct = 50mm
FOAM SEAL
Diagram 10.4
9533