GoDEX EZPL - Manual (Page 9)

4
^Fname - Download label file to printer
Syntax ^Fname
data
Parameter name = the name of label format (up to 20 characters)
data = the data containing the label formatting command for this stored format
Description Download label file to the memory of printer. After the download is completed, the
printer will beep once (refer to page76).
^Fname
:
:
^L
:
:
E
Control/Setup command
Label format command
data
Duplicate name inspection: If you use the same file name, the printer will print
“REPEAT FILE NAME”, and the format will not be stored to the memory.
Example To see ^Kname Example
^Gn - Enable/disable See-Through sensor
Syntax ^Gn
Parameter n = 0, disable see-through sensor
n = 1, enable see-through sensor
n = 2, Auto-mode
Description There are two types of sensor in printer: Reflective Sensor and See-through Sensor.
Users can set one of them as active sensor. By default, the sensor setting is set on
Auto-mode. However, sometimes the sensor may not be able to detect the label
gap on special label materials. Then it would be necessary to change the sensor
setting to other sensor. For example, when printing on labels with thick liner, colored
liner or back graphics, the see-through sensor would need to be enabled since the
reflective sensor may not work correctly.
To switch between different sensors, please do as follows:
1. Make sure that the printer is on standby mode (LED light is green) and send
below command to change the sensor setting.
2. Send "^G0" command to printer to set the Reflective Sensor as active sensor.
3. Send "^G1" command to printer to set the See-through Sensor as active sensor.
4. Send "^G2" command to printer to change the sensor setting to Auto-mode.
*For the EZ-1000Plus series, EZ-DT series, EZ-1105 / EZ-1305 and EZPi-1000 series models,
if the see-through sensor is enabled, the moveable Label Sensor must be placed in
the center of the printer.
^Hx - Print darkness setting
Syntax ^Hx
Parameter x = 00 ~ 19
Description Set the darkness of printing.
Example ^H10
^L
…..
E