Hatteland Display HT B22 (Fanless) - Manual (Page 15)

15
IND100210-13
General Installation Recommendations
Installation
Accessible Storage Device (HDD/SSD) removal / replacement HT B22
Note: Areas of interest are marked in this section with symbols in RED color. Although the trays are Hot-Swappable,
it is considered to be a good practice to power off the unit and disconnect power cable before proceeding!
▼ 1: Locate which tray you want to remove/replace and press its eject button inwards (FIG1). The hatch will
automatically open due to spring lock/unlock design.
Note: The tray may be locked/unlocked already. If the hatch does not automatically open, you can unlock it by
using a Allen Wrench tool and turn anti-clockwise. Padlock symbols (FIG 2) indicate locked or unlocked position.
FIG 2
Locked
Unlocked
FIG 1
▼ 2: Pull out the casing gently as indicated.
The tray shown here has a SSD device already
in-place. Your tray may be empty depending on
system configuration.
▼ 3: Unscrew or screw 4 pcs x M3x4mm Phillips countersunk
screws as indicated. Replace or remove the device as needed.
Make sure the device connects with the interface connector
located in the end of the tray prior to fastening screws.
- Repeat the procedure backwards to finalize operation -
For added security and to prevent accidental removal of devices during computer operation, please consider
turning the Padlock clockwise to lock the tray once in place.