Hatteland Display HT B22 (Fanless) - Manual (Page 18)

18
IND100133-52
Physical Overview - HT B22Gx STC-yzz-Mzzz
Power ON/OFF Button:
To turn ON the computer, press down button and release it immediately. The Power LED indication will illuminate blue
and the operating system will automatically boot. To turn OFF the computer, press down this button and hold it for 4
seconds. The operating system may require additionally tasks to be performed before computer shuts down and turns
off the unit.
Reset Button (Hard Reset):
To reset the computer in case of severe software failure, press this button. This reset button is a hard reset which
means the operating system will NOT be warned. Using this reset method may damage files and / or operating system
in worst case scenarios. Precaution should be taken when using this. To perform a safe software reset, press either
the power button, or use the operating system own reset functionality if possible.
Power LED:
While the unit is powered the Power LED will illuminate blue. When the unit is off the LED will also be off (not
illuminated).
2 x USB2.0 (<5m) INPUT / OUTPUT:
Supports any USB1.1 (12Mbps) and USB2.0 (480Mbps) compliant peripherals. Drivers for most USB devices are
usually included in operating system or on separate installation DVD’s delivered with Third Party products. USB 1.1
devices will operate in USB 1.1 mode (12 Mbps).
2.5” Removable SATA HDD/SSD Trays:
The unit can utilize 2 x HDD/SSD devices, 2.5” size. (1 x tray is by factory default occupied, Device #0). The
operating system and all other files will be placed on this, normally visible as drive C: The storage devices can be
easily be upgraded or replaced by pulling the HDD/SSD tray out. Both trays have their own HDD LED which will
illuminate blue when HDD is powered and/or reading/writing.
Front area of unit
Power ON/OFF Reset Button Power LED 2 x USB2.0 2.5” Removable SATA HDD/SSD Trays
Device #0 (Boot/Main)
Device #1 (Optional)
Power LED
Activity LED
Power LED
Activity LED