Hatteland Display HT B22 (Fanless) User Manual
Page 62
62
Signal Detection Note
Appendix
IND100077-131
Microsoft® Windows® XP Professional SP3, 32bit with latest graphics/motherboard drivers from MEDIA STD DVD or our website.
▼ Cable connected upon boot ▼
▼ Graphics Driver Configuration / Settings ▼
▼ Behaviour ▼
VGA Connected
DVI Connected
Single Output Mode
Cloned Output Mode
Detected
Secondary Source
Enabled Clone
Output Mode
Result:
YES
NO
YES
NO
NO
NO
YES
YES
YES
NO
YES
NO
YES
YES
NO
YES
YES
YES
YES
NO
NO
YES
NO
NO
NO
YES
NO
YES
YES
NO
Conlusion: Desired detection is NOT fulfilled for this Operating System (OS).
Note #1: Based on the fact that third-party graphics driver is not updated via other methods than those available from Hatteland Display AS.
Note #2: If Cloned Output Mode was enabled, the auto detection of “RGB/VGA” and DVI fails. Graphics Drivers has also issuses reverting back to
Cloned Mode from Single Mode. If one of the signals was lost in Cloned Mode, the drivers will automatically revert back to Single Mode and save
this setting. You have to restart the unit/OS in order to detect DVI again and then manually enable Cloned Mode, and/or choose the appropriate
signal in Single Mode as either “RGB/VGA” or DVI.