Hatteland Display HT B22 (Fanless) - Manual (Page 16)

16
IND100210-13
General Installation Recommendations
Installation
Mounting Bracket Kit (Wall / Desktop) HT B22
Mounting Bracket Kit (HT 00270 OPT-A1) is included with delivery. Note: Areas of interest are marked in this section
with symbols in RED color.
Note: In order to secure the unit properly, please use only the screws delivered with the unit. Choosing own screws
and longer than M4x8 (brackets onto unit) may cause permanent damage inside the unit and Warranty will be void !
▼ 1: Prepare the brackets, one on each side of the
unit as indicated. Make sure the bracket is rotated
correctly by aligning as red line show below.
▼ 2: Mount each bracket onto lower part of unit, using
3 pcs M4x8 CSK Torx DIN7984 on each side of the unit. It is
suggested that you add Locktite 248 (3 drops or more) to the
screws prior to fastening.
▼ 3: Place the complete unit onto your desired
location (i.e. desktop/wall) and mark the positions
you need to drill. The drilling hole should be M5.
The space under the location should allow for M5
locking nuts. Max thickness of mounting area/
plate is 8mm. If your mounting area/plate is thicker,
please assure you acquire longer screws specified
as “M5x?? Unbrako DIN916 Black”, where “??” is
your required length. View below is TOP VIEW.
▼ 4: Finalize the mounting of complete unit onto your location
using 6 pcs M5x16 Unbrako DIN916 Black (#1) with 6 pcs M5
washer DIN125 (#2) and 6 pcs M5 Locking Nut DIN985 (#3)
at the bottom as illustrated. Verifiy using hands to pull and
slide the unit to confirm it is secured tigthly onto location.
#1
#2
#3